Loading ...
Loading ...
Loading ...
Installing new belt
With lettering on
outside of belt
and positioned as
shown in box on
(D), slide new belt
over motor pulley
{B).
Replacing agitator
Securing agitator
Grasp agitator
firmly and fit it
into position by
first sliding end
opposite the belt
into the rectangular
slot (F} on side of
cleaner.
Pull other side of
agitator (G) into
place.
Turn agitator mak-
ing sure belt is not
pinched between
agitator and agita-
tor shield.
brush roll
Insert agitator
through belt and
place belt in belt
guide (C) on agita-
tor.
Should the agitator
shield (D) become
dislodged while
replacing the belt
or the agitator,
reposition it as
shown noting the
placement of its
belt guide (E).
Replacing bottom plate
Reposition bottom
plate and 4 Phil-
lips head screws.
Tighten screws
securely.
The agitator brushroll
When to replace
When agitator brushes are worn, the agita-
tor should be replaced.
To check condition of brushes, disconnect
cleaner from electrical outlet.
Move edge of a card across bottom plate
while turning agitator. To maintain clean-
ing effectiveness, replace agitator if brushes
do not touch card.
What to buy
When purchasing a new agitator, ask for one
of the fol]owing:
- HOOVERpart No. 48414132.
How to replace
Disconnectcleaner from electricaloutlet.
Removebottom J
plate, belt and agi-
tator following
directions in "The
belt" section begin-
ning with Fig, 3-10.
Discard old agitator.
Continue following
the directions in
"The belt" section
to reposition belt,
new agitator and
bottom plate.
13
Loading ...
Loading ...
Loading ...