Loading ...
Loading ...
Check agitator shield
Because your cleaner picks up so well, we
strongly recommend you check for debris
accumulation under the agitator shield each
time you clean the filters.
Removing debris under the shield will help
maintain your cleaner's excellent pick up
and suction. Remove debris as follows:
1. Disconnect cleaner from electrical outlet.
2. Check for dirt accumulation by removing
bottom plate (Pig. 3-10), removing agitator
(Fig. 3-I1), and ]ifting agitator shield (Fig.
3-13).
3. Remove any debris and replace shield,
agitator and bottom plate [Figs. 3-13 to
3-15).
Headlight replacement
(some modelsonly}
What to buy
This cleaner uses a 12 volt, wedge base type
912 bulb, Hooverpart No.27313101.
Removinglens
Disconnectcleaner
from electrical
outlet.
Using a screwdriver,
remove the two
screws as shown
and lift off lens.
Installing bulb
PuN old bulb
straight out of
socket. Push new
bulb straight into
socket until locked
in place.
Excessiveforce is
not required.
Replacing lens
Reposition lens and
secure with the two
screws.
Belt replacement
The belt on your Hoover cleaner causes the
agitator to rotate and is important for the
effective operation of the cleaner. The belt
is located under the bottom plate of the
cleaner and should be checked from time to
time to be sure it is in good condition.
When to replace
Disconnect cleaner from electrical outlet.
To check belt, remove bottom plate as shown
in "How to replace". Replace belt if it is
stretched, cut or broken.
What to buy
To assure effective operation, use only gen-
uine HOOVER belts with your cleaner. When
purchasing a new belt, ask for HOOVER part
No. 38528033.
How to replace
Disconnectcleaner
from electrical
outlet.
Removing
bottom plate
Place handle in low
position and turn
cleaner over so bot-
tom side is up. A
Remove the 4
screws as shown with a Phillips screw driver.
Lift off bottom plate (A).
Removingbelt
Remove agitator
brush roll and used
belt.
Discard used belt.
12
Loading ...
Loading ...
Loading ...