Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
f First try the solutions suggested here or visit our website at www.maytag.com/help -_
for assistance and to possibly avoid a service call.
mfyou experience PossiNe Causes SNution
Washer won't run
or fill, washer stops
working (cont.)
Washer not draining/
spinning, loads are
still wet
k,
Check proper electrical supply.
Normal washer operation.
Washer may be overloaded.
Not using HE detergent or using too
much HE detergent.
Empty pockets and use garment bags
for small items.
Use a cycle with a low spin speed.
The washer may be overloaded or
unbalanced.
Check plumbing for correct drain hose
installation. Drain hose extends into
standpipe farther than 4.5" (114 mm).
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
Washer spins the load before filling to determine load size.
Remove several items, rearrange load evenly in basket and add
detergent. Close lid and press Start!Pause/Unlock.
Do not add more than 1 or 2 additional items after cycle has
started to avoid overloading or unbalancing.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow
or stop the washer. Always measure detergent and follow
detergent directions based on your load requirements.
To remove suds, cancel cycle. Select Rhse & Spin. Press Start!
Pause/Unlock. Do not add more detergent.
Small items may have been caught in pump or between basket
and tub, which can slow draining.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/speed spin
for your garment. To remove extra water in the load, select Drain
& Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
Overloading or unbalanced loads will not allow the washer to spin
correctly, leaving the load wetter than normal. See "Using Your
Washer" for loading recommendations.
Check drain hose for proper installation. Use drain hose form and
securely attach to drainpipe or tub. Do not tape over drain opening.
Lower drain hose if the end is higher than 96" (2.4 m) above the floor.
Remove any clogs from drain hose. j
11
Loading ...
Loading ...
Loading ...