Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Check the following for
proper installation or
see "Using Your
Washer" section.
Clicking or metallic
noises
Gurgling or humming
Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load could be unbalanced.
Objects caught in washer drain
system.
Washer may be draining water.
Check the following for Washer not level.
proper installation:
Fill hoses not attached tightly.
Fill hose washers
Drain hose connection
Front and rear feet must be in firm contact with floor, and
washer must be level to operate properly. Jam nuts must be
tight against the bottom of the cabinet.
Check floor for flexing or sagging, if flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in installation instructions.
Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Do not overload. Do not fill above the stainless steel portion
of basket. Avoid washing single items.
Use Bulky cycle for oversized, non-absorbent items such as
comforters or poly-filled jackets.
See "Cycle Guide" and "Using Your Washer" in this Use and
Care Guide.
Not enough water
in washer
Washer won't run
or fill, washer stops
working
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded properly.
Load not completely covered
in water.
Check for proper water supply.
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
it may be necessary to call for service to remove items.
it is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
it is normal to hear the pump making a continuous humming sound
with periodic gurgling or surging as final amounts of water are
removed during the spin/drain cycles.
Water may splash off basket if washer is not level. Check that
load is not unbalanced or overloaded.
Tighten fill-hose connection.
Are all four fill hose flat washers properly seated?
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Improper loading can cause basket to be out of alignment
and cause water to splash off tub. See "Getting Started"
for loading instructions.
This is normal operation for an HE low-water washer. The load will
not be completely underwater. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See "What's
New under the Lid."
IMPORTANT: Do not add more water to washer. The added water
lifts the load off the washplate, resulting in less cleaning.
Both hoses must be attached and have water flowing to
inlet valve.
Both Hot and Cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
.J
10
Loading ...
Loading ...
Loading ...