Loading ...
Loading ...
Loading ...
Section 3
CO
2
Cylinder
WARNING:
This cylinder mus be installed in an open plan area or in an enclosed room, with a volume no less than 20m
3
. If more than 1
gas cylinder containing CO
2
is present within the same location, the recommended ventilated area should be in proportion to the
number of gas cylinders stored in that location.
A ventilated area is a non-enclosed area which could include the kitchen, living room etc.
See gas bottle and MSDS sheet for a complete list of warnings. (See: www.zipindustries.com)
3.1 Secure the cylinder mounting:
Secure the gas bottle supplied to a suitable wall, within 1 metre of the unit, in an upright position. This is done by screwing the
metal plate holding the Velcro strap to a cupboard wall, 200mm above the floor or base of the cupboard. Make sure the gas bottle
can stand before securing to the wall.
Due to regulatory requirements the gas bottle must be stored securely and in an upright position.
3.2 Connect the regulator:
Make sure the regulator knob is turned fully anti-clockwise to the end-stop before fitting. Fit the regulator to the gas bottle. Be aware
that some CO
2
may be discharged from the connection to the regulator as the bottle and the regulator are be assembled together.
Any CO
2
released will be cold. Continue to screw on the regulator to stop this leakage.
3.3 Connect the gas hose:
Connect the braided gas hose to the top of the undersink unit via the John Guest fitting marked ‘Gas IN’ Then connect the
threaded end to the regulator, taking care not to lose the plastic olive located inside the threaded nut. To turn the gas ON, rotate
the regulator knob clockwise and adjust to 2.7-3.0 bar (270-300kPa). The arrow should sit in the green section of the regulator
gauge; it should not fall in the red or yellow sections.
Page 10 of 20 Installation & Operating Instructions - 89914 - Zip ChillTap Sparkling - Jan 2016 v1.04
Loading ...
Loading ...
Loading ...