Loading ...
Loading ...
Loading ...
INSTALLATION 21
Connecting the Water Line
Before You Begin
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
Water hammer (water banging in the pipes) in
house plumbing can cause damage to refrigerator
parts and can lead to water leakage or flooding.
Call a qualified plumber to correct water hammer
before installing the water supply line to the
refrigerator.
_z_ CAUTION
To prevent burns and product damage,
only connect the refrigerator water line to
a cold water supply.
If you use your refrigerator before connecting
the water line, make sure the icemaker power
switch is in the OFF (O) position.
r-_ CAUTION
Do not install the icemaker tubing _n
areas where temperatures fall below
freezing.
Water Pressure
The water pressure must be between 20 and 120
psi on models without a water filter and between
40 and 120 psi on models with awater filter.
If a reverse osmosis water filtration system is
connected to your cold water supply, this water
line installation is not covered by the refrigerator
warranty. Follow the instructions carefully to
minimize the risk of expensive water damage.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (2.8 kgf/cm 2~ 4.2
kgf/cm 2,less than 2.0~3.0 sec. to fill acup of 7 oz
capacity).
"-Z_ CAUTION
h
Wear eye protection during installation
to prevent injury.
/
If the water pressure from the reverse osmosis
system is less than 21 psi or 1.5 kgf/cm 2(takes
more than 4.0 sec to fill a cup of 7 oz capacity):
• Check to see if the sediment filter in
the reverse osmosis system is blocked.
Replace the filter if necessary.
• Allow the storage tank on the reverse
osmosis system to refill after heavy
usage.
• If water pressure issues associated with
a reverse osmosis system persist, call a
licensed, qualified plumber.
• All installations must be in accordance
with local plumbing code requirements.
What You Will Need
Copper Tubing, 1A in. outer diameter, to
connect the refrigerator to the water
supply. Be sure both ends of the tubing
are cut square.
To determine how JJ
much tubing you need:
measure the distance
from the water valve on the back of
the refrigerator to the water supply
pipe. Then, add 8 feet (2.4 m). Be sure
there is sufficient extra tubing (about 8
feet [2.4 m] coiled into 3 turns of about
10 in. [25 cm] diameter) to allow the
refrigerator to move out from the walt
after installation.
Powerdrill.
• 1/2in. or adjustable
wrench.
• Flat blade and Phillips
head screwdrivers.
Two 1/_ in. outer
diameter compression
nuts and 2 ferrules (sleeves) tO connect the
copper tubing to the shutoff valve and
the refrigerator water valve.
Loading ...
Loading ...
Loading ...