Loading ...
Loading ...
Loading ...
WARNING:
Yourtablesaw hasa precision builtelectric motor. Itshould
only be connected to a power supply that is 120 volts,
60 Hz,AC only(normal household current). Do notoperate
this tool on direct current (DC). A substantial voltage drop
will cause a loss of power and the motor will overheat. If
your tool does not operate when plugged into an outlet,
double check the power supply.
ON/OFF SWITCH KEY
Your Ryobi table saw is equipped with an on/off switch key
that, if removed, prevents the saw from being turned on. The
key must be in place to turn the saw on. Ifthe key is removed
during operation, the saw may be turned off but may not be
turned on again until the key is replaced. See Figure 8.
Fig. 8
GROUNDING
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped with
an electric cord having an equipment-grounding conductor
and a grounding plug. The plug must be plugged into a
matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installedby a qualified electrician.
Improper connectionofthe equipment-groundingconductor
canresult in electricalshock.The conductorhavingan outer
surface that is green with or without yellow stripesis the
equipment-groundingconductor.Ifrepair or replacementof
the electriccord or plug is necessary, do not connectthe
equipmentconductorto a liveterminal.
_ WARNING: I
If an extension cord is used, make sure it is a grounded/I
3-prongplug and is adequatetoprevent excessive voltage I
loss.See ExtensionCord Caution on back page. J
Check with a qualified electrician or service personnel ifthe
grounding instructions are not completely understood, or if
in doubt as to whether the tool is propedy grounded.
Repair or replace a damaged or worn cord immediately.
This tool is intended for use on a circuit that has an outlet
like the one shown in Figure 9. It also has a grounding pin
like the one shown.
GRO ,"=NG\
COVEROFGROUNDED
OUTLETBOX
Fig. c
#
OVERLOAD RESET BUTTON
Your Ryobitable saw features an overload reset button. In
the eventthat your saw turnsoffduringoperation,turnthe
saw offand allowthe motorto cooldownfor approximately
3 minutes.Pushtheresetbuttonandattempttoturnthesaw
on again. Ifthe saw does notturnon,turntheswitchoffand
checkall cordsfor properconnectionand retry.Ifitstilldoes
notturnon,contactyourauthorizedRyobiServiceCenter.If
itturnson and then cutsoffwhileyou are working,you may
be trying to feed the workpiece too quickly or may be
operatingwitha dullblade or may be tryingto operateon a
circuitprovidinginsufficientvoltage.
SPEED AND WIRING
The no-loadspeed ofyoursaw isapproximately 4,800 rpm.
This speed is not constantand decreases undera load or
with lower voltage. A line intended only for lightscannot
properlycarrya powertoolmotor.Wirethatisheavyenough
fora shortdistancewillbe too lightfor a greaterdistance.A
line that can support one power tool may not be able to
supporttwo or three.
Page 12
Loading ...
Loading ...
Loading ...