Loading ...
Loading ...
Loading ...
Attach blade guard assembly to support bracket with
M6 x 19 mm carriage bolt. Secure with a 1/4" flat washer,
external tooth lock washer and wing nut.
NOTE: Before tightening wing nut, make sure there is at least
1/8" (3 mm) between the end of the table and blade guard
assembly. Also check to make sure that the two circular tabs
are still engaged inside the upper hole and slotted opening.
Raise the saw blade by turning the control wheel handle
counterclockwise.
Raise the transparent blade guard, then use a straight edge
to make sure that the blade guard assembly is aligned with
the saw blade.
If the blade guard assembly is not aligned with the blade,
loosen the 1/2"hex head bolts and/or the 2-1/4" socket head
bolt and reposition the blade guard assembly so that it is
aligned with the blade. Oncealigned, securely tighten all bolts.
_ WARNING: I
Failure to confirm blade guard assembly is properly
alignedwiththe bladecouldcause theworkpiecetojam
while sawing,causingkickbackand injury,
INSTALL MITER GAUGE
To install the pre-assembled miter gauge, simply slide the
long end of the miter gauge into the miter gauge channel as
shown in Figure 7.
INSTALLING THE RIP FENCE LOCK DOWN
HANDLE
Locate the lock down handle and an M4 x 15 mm tapping
screw.
Slide the handle overthe exposed end ofthe ripfence. Make
sure the handle isinserted as far as itcan go. The hole in the
metal rip fence should line up with the recessed hole in the
handle. Secure handle using the M4 x 15 mm tapping screw.
Fig. ?
i
INSTALLING THE RIP FENCE
The rip fence attaches to the rear andfront railsbytwo flanges
on either end of the fence, When the lock down handle is in
the Up position (parallel tothe fence), theflanges are relaxed,
allowing you to reposition the rip fence. When the lock down
handle is in the Down position (perpendicular to the fence),
the flanges are drawn together and the rail is held in place.
Toinstall the rip fence, place the end furthest from the handle
so that the flange is over the rear edge of the table: Then
lower the end closest to the lock down handle over the front
rail.
NOTE: Foraccuratealignment,makesurethatthefrontblock
isflushagainstthefront rail.
Push the lockdownhandle downtofixthe railin place.
Page 11
Loading ...
Loading ...
Loading ...