Loading ...
Loading ...
Loading ...
54
Design Features
Power/Protect LED
Power LED illuminates blue when the unit is turned on. Protect
LED illuminates yellow if a short circuit or to low of an impedance
is detected at the speaker connections. Thermal LED illuminates
red when amplifier overheats. The amplifier will automatically shut
down if this occurs.
Output Clip Indicator Chart
Reference chart for the output clip in-
dicator LED illumination color during
input level setup.
Speaker Terminals
The Speaker Terminals are nickel-plated
captive c-clamp wire connectors (+ and -)
will accommodate 8 AWG.
RCA Input/Pass-Thru
The RCA inputs are capable of accepting signal from either high-level(speaker) to low-
level(RCA). When utilizing high-level for input signal the auto turn-on feature is active.
The pass-thru RCA’s are passive, including full input signal range and auto turn-on
functionality when active.
Subwoofer Input
Setting this switch to the “On” position, utilizes the
“Sub” inputs. (P1000X5)
Centering Indicators
Indicators are located on the bottom side of the
amplifier.
Output Clip Indicator
The output clip indicator works in conjunction with
the input level knob, illuminating to appropriate
color depending on the audio content used for the
setup.
Intput Clip Indicator
The input clip indicator works in con-
junction with the audio source volume
knob, illuminating red when audio
source reaches it’s clipping point.
Input Level Knob
The input level control is used to match
the output of the audio source.
Design Features
Punch EQ
A Gyrator based Punch EQ that eliminates frequency
shift with boost. This works along with the crossover
switch on the amplifier.
Power/REM Terminals
The power and ground will accommodate 4 AWG,
while the remote will accommodate 12 AWG.(The
REM terminal is used to remotely turn-on and
turn-off the amplifier when +12V DC is applied.)
2/4 Channel Switch
Setting this switch to the 2CH. position, switches the
inputs to a 2-channel mode, allowing connection to
only the front inputs with a 4-channel output. (P400X4,
P600X4, P1000X5)
Crossover Switch
Selectable switch for High-Pass (HP) or
All Pass (AP) or Low-Pass (LP)
Variable Crossover
Is a built-in 12dB/octave Butterworth filter with
a crossover point variable from 50Hz to 250Hz.
illus.-1.1
Remote Punch Level Control - In/Out
Remotely control the output level of the amplifier. The
PLC-OUT is used to daisy-chain additional amplifiers
controlled by a single remote.
Infrasonic Filter
A fixed 28Hz 12dB/octave filter designed to prevent
frequencies below the audio range from being applied
to the subwoofer from the amplifier. Consequently
improving subwoofer performance and power han-
dling, particularly in vented enclosures. (P500X1BD,
P10001BD, P1000X5)
Remote Punch Level Switch
When activated, this allows the use of a optional re-
mote Punch Level Controller. (P500X1BD, P10001BD,
P1000X5)
INPUT CLIP
REAR SUBFRONT
RIGHT
LEFT
RIGHT
LEFT
B+
REM GND
REMOTE
PUNCH LEVEL
PLC-OUTPLC-IN
FRONT REAR
RIGHTLEFT
BRIDGED
RIGHTLEFT
BRIDGED
SUB
BA
SPEAKERS
INPUT
2CH. - 4CH.
Loading ...
Loading ...
Loading ...