Loading ...
Loading ...
Loading ...
Escape 1800-I Insert Installation and Operation Manual
12
ash lip, make sure you always leave at least 1 5/8 inch between the last log and the inner
wall of the combustion chamber. There should be air space between each log and between
the logs and the bricks. Let the door ajar at 90° for approximately two minutes and then close
the door.
2.4.3 Medium and low burn rate
On a 2˝coal bed that is still slightly red, place five logs of approximatively 4˝x 4˝ or 3˝x 3˝
with an East- West orientation. Place a medium log at the back. Place the biggest log in the
center with a medium one on top of it. Place a medium on the front and another medium on
top of it. If you need to stack the front pieces over the ash lip, make sure you always leave
at least 1 5/8 inch between the last log and the inner wall of the combustion chamber. There
should be air space between each log and between the logs and the bricks. Let the door
ajar at 90° for approximately 5 min. Then, close the door with the primary air control open.
Leave to burn with the primary air control open for approximately 10 minutes and then close
the primary air control completely for the low burn rate and halfway for the medium burn
rate.
2.4 Zone Heating and How to Make It Work for You
Your new Escape 1800-I wood insert is a space heater, which means it is intended to heat
the area it is installed in, as well as spaces that connect to that area, although to a lower
temperature. This is called zone heating and it is an increasingly popular way to heat homes
or spaces within homes.
Zone heating can be used to supplement another heating system by heating a particular
space within a home, such as a basement family room or an addition that lacks another heat
source.
Houses of moderate size and relatively new construction can be heated with a properly sized
and located wood insert. Whole house zone heating works best when the insert is located
in the part of the house where the family spends most of its time. This is normally the main
living area where the kitchen, dining and living rooms are located. By locating the insert in
this area, you will get the maximum benefit of the heat it produces and will achieve the
highest possible heating efficiency and comfort. The space where you spend most of your
time will be warmest, while bedrooms and basement (if there is one) will stay cooler. In this
way, you will burn less wood than with other forms of heating.
Although the insert may be able to heat the main living areas of your house to an adequate
temperature, we strongly recommend that you also have a conventional oil, gas or electric
heating system to provide backup heating.
Your success with zone heating will depend on several factors, including the correct sizing
and location of the insert, the size, layout and age of your home and your climate zone.
Three-season vacation homes can usually be heated with smaller inserts than houses that
are heated all winter.
Loading ...
Loading ...
Loading ...