Loading ...
Loading ...
Loading ...
Page 12
OPERATION
REMOVE THE OPEN-LOOP
ACCESSORY
FIG. 5d
1. Make sure that the on/off switch is in
the OFF position and remove the battery
pack.
2. Turn the quick-release lever
counterclockwise until you hear a
“click” sound.
3. Remove the accessory from the tool.
NOTICE: Attach the accessory in the
desired orientation for the task at hand.
The shaft is configured so that most
application accessories can be installed
around the tool in 30° increments.
WARNING:
A blade should never
be attached so that it is facing backwards,
as operation in this position may cause
serious injury (FIG.5d).
WARNING:
Always wear protective
gloves when changing accessories. The
edges of the accessories are sharp and
can become very hot after working.
WARNING:
Check that the
accessories are correctly attached.
Incorrectly or insecurely fastened
accessories can come loose during
operation and cause a hazard.
NOTICE: The closed-loop accessories can
also be installed on the multi-tool.
1. Open the quick-release lever.
2. Unlock and remove the flange bolt.
3. Put the closed-loop accessory on the
accessory plate, insert the flange bolt
into the hole, and then lock the flange
bolt.
4. Turn the quick-release lever back.
CUTTING
Saw blades are ideal for making precise
cuts in tight areas, close to edges or flush
to a surface.
1. Select a medium to high speed for
making the initial plunge.
2. Start at medium speed for increased
control.
3. After making your initial cut, you may
increase speed for faster cutting.
Loading ...
Loading ...
Loading ...