Loading ...
Loading ...
Loading ...
High pressure air could
result in death or serious injury. Shut off unit,
unplug and release air pressure prior to
servicing.
High pressure air
containning water condensation could
result in minor or moderate injury. Do
not spray at any person.
Risk of serious eye injury
from moisture and debris. Always wear ANSI
Z87.1 safety goggles when opening ball
valve.
Operating Instructions
WARNING:
WARNING:
CAUTION:
5. Set the power switch to the ON position
and allow the tank pressure to build. Motor
will stop when tank pressure reaches cut-out
pressure(Fig H).
Shut down
1. Set the power switch (1) to the OFF
position.
2. Unplug the power cord (2).
3. Reduce the pressure in the tank through
the outlet hose. Pulling the safety valve ring
(3) and keeping it open will also reduce the
pressure in the tank(fig. I).
4.Set tank ball valve(4) (fig. I) to OFF to
ensure tank is drained.
1
3
4
2
FIG. I
Drain the tank
1. Set the power switch to the O (OFF)
position.
2. Turn air pressure regulator knob
counter-clockwise to set the outlet pressure
to zero.
3. Pull and hold ring on safety valve, allowing
air to bleed from the tank until air pressure is
minimized.
4. Place a suitable container under the unit to
catch any water.
5. Slightly tilt unit and turn ball valve.
counter-clockwise to open.
6. After the water has been drained,close
the ball valve(clockwise). The air compressor
can now be stored.
4. Close the tank ball valve(1) . Plug-in
the power cord(2) (FIG. G).
2
1
O
FF
O
N
F
I
G.
G
FIG. H
Page 12
ONOFF
OFF
Loading ...
Loading ...
Loading ...