Loading ...
Loading ...
Loading ...
Operation • Maintenance 4
For automatic operation, plug or wire pump into an
automatic float switch or pump controller. Pump will run
continuously when plugged directly into an electrical
outlet. Connect or wire pump to its own individual branch
circuit with no other outlets or equipment in the circuit.
Size fuses or circuit breakers according to Specifications.
Risk of electric shock. Can shock, burn
or kill. Be sure that power supply information (Voltage/
Hertz/Phase) on pump motor nameplate matches incoming
power supply exactly. Install pump according to all
electrical codes that apply.
Operation
NOTICE Do not allow pump to run in a dry sump. It will
void the warranty and may damage the pump.
An automatic overload protector in the motor will
protect motor from burning out due to overheating/
overloading. When motor cools down, overload
protector will automatically reset and start motor.
If overload trips frequently, check for cause. It could be
a stuck impeller, wrong/low voltage, or electrical failure
in motor. If an electrical failure in the motor is suspected,
have it serviced by a competent repairman.
Pump is permanently lubricated. No oiling or greasing
isrequired.
Maintenance
Risk of electric shock. Can shock, burn
or kill. Before removing pump from basin for service,
always disconnect electrical power to pump and control
switch.
Risk of electric shock. Can shock, burn or
kill. Do not lift pump by power cord. See “Cord Lift
Warning” below.
Submerge pump in a disinfectant solution (chlorox or
chlorine) for at least one hour before disassembling pump.
The pump motor contains a special lubricating oil which
should be kept clean and free of water at all times.
Check operation by filling sump with water and
observing pump operation through one complete cycle.
Risk of flooding. Can cause personal injury
and/or property damage. Failure to make this operational
check may lead to flooding and premature failure.
NOTICE This unit is not designed for applications
involving salt water or brine! Use with salt water or brine
will void warranty.
For parts or assistance, call Simer Customer Service at 800-468-7867
1. Attempting to lift or support pump
by power cord can damage cord and
cord connections.
2. Cord may pull apart, exposing bare
wires with possibility of fire or electri-
cal shock.
3. Lifting or supporting pump by power
cord will void warranty.
4. Use lifting ring or handle on top of
pump for all lifting/lowering of pump.
Disconnect power to pump before
doing any work on pump or attempt-
ing to remove pump from sump.
Risk of electrical
shock.
Can burn or kill.
Do not lift pump by
power cord.
WARNING
CORD LIFT WARNING
Loading ...
Loading ...
Loading ...