Loading ...
Loading ...
Loading ...
Page 11
MAINTENANCE
OPERATION
7. 3-SPEED SWITCH BUTTON
The driver has 3 speeds for your selection.
Press the 3-speed switch button (8) to select the
required speed. Select the low speed, the right
light is on green.Select the middle speed, the
middle light is on green.Select the high speed,
the left light is on green. (See Fig. G)
8.USING THE LED LIGHT
To turn on the light, press the on/off switch and
make sure the forward/reverse rotation control
is on right/left position. When you release the
on/off switch, the light remains lit for a period of
time and then will be off.
LED lighting increases visibility-great for dark or
enclosed area.
9.BELT CLIP
Screw the Belt Clip (6) on the tool with the screw
provided in the plastic bag. The Belt Clip (6) can
be hooked on your belt or pocket, etc.
10. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop.
Relieve the load on the machine immediately
and allow cooling for approx. 30 seconds at the
highest no-load speed.
11. TEMPERATURE DEPENDENT
OVERLOAD PROTECTION
When using as intended for the power tool
cannot be subject to overload. When the load
is too high or the allowable battery temperature
of 75°C is exceeded, the electronic control
switches off the power tool until the temperature
is in the optimum temperature range again.
12. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep
discharging by the “Discharging Protection
System”. When the battery is empty, the
machine is switched off by means of a
protective circuit.
Remove the battery pack from the machine before carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of tool and battery is 0
o
C-45
o
C (32°F-113°F).
The recommended ambient temperature range for the charging system during charging is 0
o
C-40
o
C
(32°F-104°F).
Fig. G
8
L: 1500/min
M: 2100/min
H: 3200/min
Loading ...
Loading ...
Loading ...