Masterforce 709-3954 Owner's Manual

Loading ...

– 7 –

FIGURE 8

FIGURE 9

INSTALLING THE ANGLE GUIDE

1. The angle guide is designed to ﬁt on top of the

rip guide. Simply place angle guide onto the

top of the rip guide. (see FIGURE 10)

NOTE: The angle and rip guides can be placed on

either the left or right side.

FIGURE 10

OPERATION

IMPORTANT: ALWAYS turn off the saw and

remove the plug from the outlet BEFORE adding

or removing accessories and making adjust-

ments.

FAILURE TO UNPLUG

THE SAW COULD RESULT IN ACCIDENTAL

STARTING CAUSING POSSIBLE SERIOUS

PERSONAL INJURY.

BEFORE STARTING THE SAW

1. Make sure saw is unplugged.

2. Remove the right cutting table, secure the

waterplug and ﬁll the water reservoir to the

ﬁll line (see FIGURE 11). Do not ﬁll above this

level.

NOTE: ALWAYS keep enough water in the

reservoir when operating the saw. DO NOT let

the saw run dry.

3. Re-attach and close right cutting table.

IMPORTANT: ALWAYS completely drain the

water reservoir and clean thoroughly after

each use.

FIGURE 11

TO START THE SAW

1. Remove cord from side compartment and

connect it to a GFCI (Ground Fault Circuit

Interrupter) protected outlet

(See FIGURE 12)

3.Push On/Off switch to the “On” position.

FIGURE 12

Loading ...

Masterforce 709-3954 - 7" 1HP Wet Tile Saw