Loading ...
Loading ...
Loading ...
– 6 –
FIGURE 4
3. Remove blade shaft nut and outer flange.
4. Carefully place the blade onto the shaft and
push it against the inner flange.
5. Be sure the side of the blade with the
directional arrow is facing towards you.
6. Place the outer flange and the blade shaft
nut onto blade.
7. Hold blade and firmly tighten the blade shaft
nut with the included wrench, but do not
over tighten (see FIGURE 5).
FIGURE 5
8. Replace baffle and right cutting table.
USE ONLY
CONTINUOUS RIM BLADES WITH THIS SAW.
DO NOT USE SEGMENTED, “TURBO” BLADES,
WOOD SAWING BLADES, BLADES WITH
OPENINGS, OR ANY OTHER CUTTING DEVICES
WITH THIS TILE SAW. USING THESE BLADES
COULD RESULT IN SERIOUS PERSONAL
INJURY AND DAMAGE TO THE SAW.
INSTALLING THE BLADE GUARD
1. Remove the 2 screws on top of the table,
behind the blade slot.
2. Insert blade guard support to align with the
holes where the screws were removed. Adjust
the blade guard support so that the support
aligns with the blade.
3. Insert the 2 screws and tighten (see
FIGURE 6).
FIGURE 6
3. Slip the back end of the blade guard down
over the blade guard support (see FIGURE 7).
4. Replace the knob into the blade guard, while
being careful to hold bolt on the right side in
place, then tighten (see FIGURE 7).
FIGURE 7
5. It is suggested that the front of the blade
guard be pointed slightly down to minimize
the front splash during cutting.
INSTALLING THE RIP GUIDE
1. Slip the back of the rip guide on the back
edge of the table (see FIGURE 8)
2. Place front of rip guide down on the front
edge of the saw.
3. Adjust position to the size of the cut needed,
and flip down lever to lock rip guide in place.
(see FIGURE 9)
4. The round knob over the lever is also used
to further tighten the rip guide.
PINCH POINT.
KEEP HANDS CLEAR OF HINGED LEVER WHEN
LOCKING AND UNLOCKING RIP GUIDE.
Loading ...
Loading ...
Loading ...