Loading ...
Loading ...
Loading ...
14
INSTALLING THE RIP GUIDE
1. Loosen the rip guide adjusting knob (1)
(Fig. 7).
2. Slide the rip guide rod (2) into the rip guide
slot (3). Continue to slide the rip guide rod
across the sole plate and into the rip guide
slot under the rip guide adjusting knob.
3. Adjust the rip guide shoe to the correct
distance from the blade and tighten the rip
guide adjusting knob.
LIVE WIRE INDICATOR
The live wire indicator (1) will turn ON when the
plug is inserted into a "live" 110V receptacle
(Fig. 8). If the live wire indicator fails to turn on,
this indicates the plug is not inserted into a "live"
receptacle.
LED WORKLIGHT
The LED worklight (1) will turn ON automatically
when the tool is plugged into the power supply
(Fig. 9). It will turn OFF when the plug is
removed from the power supply.
ASSEMBLY AND OPERATING
WARNING
!
For safety reasons, the operator must
read the sections of this Owner’s Manual
entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL SAFETY",
"SPECIFIC SAFETY RULES",
"EXTENSION CORD SAFETY" and
"SYMBOLS" before using this circular
saw.
Verify the following every time the
circular saw is used:
1. The blade is tight and sharp.
2. All adjustments are tight.
3. The workpiece is properly secured.
4. Safety glasses and hearing
protection are being worn.
Failure to adhere to these safety rules can
greatly increase the chances of serious
injury.
Fig. 8
Fig. 7
Fig. 9
Loading ...
Loading ...
Loading ...