Masterforce 2410747 15-Amp Corded 7-1/4" Circular Saw with Electric Brake

User Manual - Page 13

For 2410747.

PDF File Manual, 24 pages, Read Online | Download pdf file

2410747 photo
Loading ...
Loading ...
Loading ...
13
Fig. 4
SETTING THE CUTTING DEPTH
The cutting depth of the blade should be set to
suit the thickness of the material being cut. The
cutting depth should be approximately 1/8"
(3 mm) greater than the thickness of the
material being cut.
1. Lift the depth adjustment locking lever (1)
upward (Fig. 4).
2. Pull the sole plate (2) downward until the
correct amount of the blade is protruding
below the sole plate.
NOTE: The depth indicator (3) will identify the
relative depth of cut on the scale (4).
3. Lock the sole plate at the correct depth by
pushing the depth control locking lever
downward.
NOTE: Make a test cut on a scrap workpiece to
verify the depth setting.
SETTING THE BEVEL CUTTING ANGLE
The sole plate can be tilted to provide bevel cuts
from 56°.
1. Lift the bevel angle locking lever (1)
upward (Fig. 5).
2. Rotate the sole plate (2) to the desired
angle as shown on the bevel gauge (3).
3. Lock the sole plate at the correct angle by
pushing the bevel angle locking lever
downward.
NOTES:
a) The bevel angle will automatically stop at 45°.
To cut at bevel angles greater that 45°, press
the 45° stop button (4) and continue to rotate
the sole plate to the desired angle.
b) Make a test cut on a scrap workpiece to verify
the bevel angle setting.
ADJUSTING THE ANGLE STOP
1. Set the bevel angle to 0° (1) (Fig. 6).
2. Use a carpenter’s square to check the
angle between the blade and the sole
plate.
3. If the angle is NOT 90°, use a 2.5 mm hex
key and adjust the set screw (2) so the
angle is 90° when the stop contacts the
set screw.
NOTE: Make a test cut to verify that the saw is
cutting at 90°.
ASSEMBLY AND OPERATING
Fig. 5
Fig. 6
Loading ...
Loading ...
Loading ...