Loading ...
Loading ...
Loading ...
8
Assembling Your
Multi-Purpose Steam Cleaner
STEAM CLEANING ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
JET NOZZLE / SQUEEGEE / CORNER TOOL
1. Select one of the three accessories (Jet Nozzle, Squeegee or Corner Tool – Jet Nozzle shown
as example), and align rear end of accessory with Steam Nozzle. Rectangular hole in selected
accessory should align with blue lock/release button on Steam Nozzle.
2. Press down on blue lock/release button (FIGURE 4-A). While continuing to hold button down,
slide accessory onto Steam Nozzle (FIGURE 4-B). Push accessory over button, and continue
pushing until button snaps through rectangular hole.
NOTE: The Jet Nozzle, Squeegee and Corner Tool can be connected to the end of an
Extension Wand for reaching high or difcult spots. Connect the Extension Wand
(or wands) as outlined on Page 6, then connect your desired accessory to the wand
in the same way as you would normally connect it to the Steam Nozzle.
CORNER TOOL PADS
NOTE: This procedure applies to the Corner Tool Scrub Pad and Corner Tool Sponge Pad.
1. Swing Corner Tool latch arm to open position (FIGURE 5-A).
2. Press desired pad against Corner Tool (FIGURE 5-B). The pad should wrap around angled
edge, covering all steam holes.
3. While continuing to hold pad against Corner Tool, swing latch arm over pad to locked position
(FIGURE 5-C). This will secure the pad in place.
FIGURE 4
FIGURE 5
4-A
4-B
5-A 5-C
5-B
Loading ...
Loading ...
Loading ...