Loading ...
Loading ...
Loading ...
HP Cylinder
Installatio
n and User Instructions R03184
-4 09/15
Page
41
Operation
When using the A Class cylinder and
heat pump, the DHW temperature is
set using the heat pump user interface
and can be adjusted up to 65°C to
meet user requirements however the
lower the set temperature the more
energy efficient the system will
become.
When turning on a hot tap for the first
time after a heat up period there might
be a short surge of water. This is
normal in unvented systems and does
not constitute a fault. Sometimes the
water may appear milky – this is due
to very fine air bubbles in the water
which will clear quickly.
9.2.1 Water Temperature
Direct Electric Heating
Before removing the cover
from the immersion heater
isolate appliance using
isolating switch! Danger of
electrical shock! Only use
suitable electrically insulated
equipment when working
inside immersion housing.
The hot water temperature achieved by
the direct electric heating element can
be adjusted by removing the cover
from the immersion heater and
adjusting the dial up or down as
indicated in Figure 23.
Figure 23: Adjustment Water Temperature Direct Electric Heating Element
Dial to adjust water
temperature
Loading ...
Loading ...
Loading ...