Loading ...
Loading ...
Loading ...
20
ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connecting 3-Wire Connection: Power Supply Cord (cont.)
2. Connect white neutral wire (white or center) (D) to center
terminal block. Tighten screw.
3. Connect remaining wires with outer terminal block screws (F).
Tighten screws. Finally, re-install terminal block cover and tighten
hold-down screw. Go to “Complete Installation” section.
D
F
F
ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY)
Direct Wire Connection
4-wire direct
Go to “Connecting 4-Wire Connection: Direct Wire” section.
1"
(25 mm)
5"
(127 mm)
3-wire direct
Go to “Connecting 3-Wire Connection: Direct Wire” section.
NOTE: If local codes do not permit connection of a cabinet-ground
conductor to neutral wire, go to “Connecting 3-Wire Connection:
Optional” section. This connection may be used with either a power
supply cord or a direct wire connection.
WARNING
Fire Hazard
Use 10 gauge copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal.
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals.
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Connection Options
Direct Wire
Loading ...
Loading ...
Loading ...