Loading ...
Loading ...
Loading ...
Page 10
BLADE
If the blade is worn out, replace it with a new
one (not provided).
1. Insert a metal rod (e.g. a screwdriver) into
the hole on the shaft under the blade to x
the blade in place.
2. Remove the nut (2) by turning it
counterclockwise with the wrench (4)
provided.
3. Remove the washer (3).
4. Remove the old blade and replace it with a
new one.
5. Place the washer (3) on the blade.
6. Place the nut (2) on the washer (3) and
tighten it counterclockwise with the wrench
(4) provided.
OPERATION TIPS
Always hold the edger away from the body
keeping clearance between your body and
the edger. Any contact with the edger cutting
head while operating can result in serious
personal injury.
• Hold the edger
with your right hand
on the rear handle
and your left hand on the front handle.
• Keep a rm grip with both hands while in
operation.
• Edger should be held at a comfortable
position with the rear handle about hip
height.
• The edger will edge along sidewalks,
driveways, ower beds, curbs, and similar
areas.
• Cut at a steady pace. If the blade begins
to bog down, you are edging too fast; slow
your pace. Do not force the blade into the
ground.
• Light contact of the blade against the
sidewalk edge, curb, etc., is acceptable
and will not damage the edger.
• Best appearance is obtained when grass
is dry. Avoid edging in wet soil or wet grass
areas or the blade guard might clog and
result in an uneven edge. If the blade guard
becomes clogged, stop the edger, remove
the battery, and remove debris from the
blade guard.
WARNING
OPERATION
FIG. 5
FIG. 6
FIG. 4
FIG. 5
FIG. 6
Loading ...
Loading ...
Loading ...