Loading ...
Loading ...
Loading ...
Page 9
ADJUST THE DEPTH OF CUT
1. Remove the battery pack.
2. Loosen the depth adjustment knob to
increase or decrease the depth.
3. Adjust the depth so that the blade barely
touches the ground when the machine is
held in a normal operating posture.
4. Tighten the depth adjustment knob.
5. Standing in a normal working position,
check the depth of cut again and correct if
necessary.
6. Replace the battery pack once all
adjustments are complete.
Read and under-
stand entire Operator's Manual for each
optional attachment used on this power
head and follow all warnings and instructions.
Failure to follow all instructions may result in
electric shock, re and/or serious personal
injury.
Do not allow familiarity with this product to
make you careless. Remember that a care-
less fraction of a second is sufcient to inict
serious injury.
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or acces-
sories not recommended can result in serious
personal injury.
LOCK-OUT SWITCH
The lock-out button reduces the possibility
of accidental start-up. The lock-out button is
located on the handle above the switch trig-
ger. The lock-out button must be depressed
before you pull the switch trigger. The lock
resets each time the trigger is released.
START / STOP THE TRIMMER
1. Ensure a fully charged battery is installed
into the edger.
2. To start the edger, press and hold the
lock-out button (1) and squeeze the switch
trigger (2).
OPERATION
WARNING
FIG. 1
FIG. 2
FIG. 3
Loading ...
Loading ...
Loading ...