Napoleon GDS28-1NE Haliburton Direct Vent Gas Stove

User Manual - Page 23

For GDS28-1NE. Also, The document are for others Napoleon models: GDS28-1NSB, GS28-1N, GS28-1NE

PDF File Manual, 108 pages, Read Online | Download pdf file

GDS28-1NE photo
Loading ...
Loading ...
Loading ...
EN
W415-2339 / C / 02.08.21
23
installation
3.2 appliance vent connection
A. Attach the adjustable pipe to the last section of rigid pipe. Secure with
screws and seal.
B. Install the inner fl ex pipe to the appliance. Secure with a minimum of
three screws and fl at washers when installing 3”/5”, 4”/7” or 5”/8”
venting, or six screws and fl at washers when installing 8”/10” or
8”/11” venting. Seal the joint and screw holes using Mill Pac sealant
(W573-0007) (not supplied).
C. Run a bead of high temperature red RTV silicone sealant (W573-
0002) (not supplied) around the inside of the air intake collar. Pull the
adjustable pipe a minimum 2” (50.8mm) into the air intake collar.
INSERT
IMAGE HERE
note:
Always fi nish vent system installation with the appliance vent connection. Ensure that the sealant is not visible on the
exterior pipes once installation is completed. An optional decorative black band may be available with this appliance.
In the event that the venting must be disassembled, care must be taken to reseal the venting.
2” (50.8mm)
Overlap
Mill-Pac
Sealant
#8 X 1/2”
Self Drilling
Screws
3.3 natural vent specifi cs
3.3.1 chimney installation
!
WARNING
A chimney venting this appliance shall not vent any solid fuel burning appliance.
Three types of chimney systems may be used with this appliance.
All horizontal runs must have a 1/4” (6.4mm) rise per foot (0.3m)
“A” VENT - SOLID
FUEL WOOD BURNING
CHIMNEY & VENT
CONNECTOR
(LINER NEEDED IF
INSIDE DIAMETER
IS 6” (152mm) OR
LARGER
SINGLE WALL OR
“B” VENT
MASONRY CLAY
LINED CHIMNEY +
VENT CONNECTOR
(NO NEW LINER
NEEDED IF OLD
LINER DIAMETER IS
4-5” (102-127mm)
SINGLE WALL OR
“B” VENT
“B” VENT GAS
BURNING
CHIMNEY
3.3.2 combustion air
This appliance needs air for safe operation and must be installed in such a way that adequate combustion air is
available.
Loading ...
Loading ...
Loading ...