Masterforce VF408 OPERATOR’S MANUAL

Loading ...

Page 15

INSTALLING & CLEANING FILTERS

Installing Cartridge Filter

1. Verify that the power cord is disconnected

from the outlet. (fig. 1)

Fig. 1

2. Remove power head and place in upside

down position.

3. Install the cartridge filter over the filter cage

with the flat end of the filter towards the

vacuum power head. Carefully push filter in

until it stops against the power head. (fig. 2

& 3)

Fig. 2 Fig. 3

4. Place filter retainer on top of cartridge filter

over the raised lip and tighten down by

turning retainer clockwise, taking care not

to over-tighten. (fig. 4 & 5)

Fig. 4 Fig. 5

Removing and Cleaning Cartridge Filter

1. Unlock and remove the filter retainer by

turning retainer handle counter clockwise.

2. Carefully hold and pull the cartridge filter up

for removal. (fig. 6)

Fig. 6

3. Clean the cartridge filter by gently tapping

or brushing dirt off. Cleaning should not be

done indoors in living areas. For optimal

performance a new filter is recommended.

4. Install cleaned or new filter into place as

instructed above in steps 1 - 4 of Installing

Cartridge Filter.

5. Wet filters should be removed and allowed

to air dry for 24 hours before installing onto

the filter cage.

Installing and Cleaning HEPA Filter

1. Verify that the power cord is disconnected

from the outlet. (fig.1)

Fig. 1

Loading ...

Masterforce VF408 4 Gallon 5 Peak HP Wet/Dry Shop Vacuum