Loading ...
Loading ...
Loading ...
Page 8
IMPORTANT: This converter uses a nonsinusoidal waveform, which is not
the same as power company electricity. Therefore, we do not recommend
you use it to power the following devices:
1.
Switch mode power supplies
2.
Linear power supplies
3.
Class 2 transformers
4.
Line filter capacitors
5.
Shaded pole motors
6.
Fan motors
7.
Microwave ovens
8.
Fluorescent and high intensity lamps (with a ballast)
9.
Transformerless battery chargers
Using the converter with any of these devices may cause the device to run
warmer or overheat.
IMPORTANT: If you are using the power converter to operate a battery
charger, monitor the temperature of the battery charger for about 10
minutes. If the battery charger becomes abnormally warm, disconnect
it from the converter immediately.
NOTE: You can use an extension cord from the converter to the device without
significantly decreasing the power being generated by the converter. For best
operating results, the extension cord should be no longer than 50 feet.
4. FASTENING THE CONVERTER TO A FLAT SURFACE
For convenience, your converter can be fastened to a flat surface, horizontally
or vertically. The area where the converter is to be fastened must be dry, well
ventilated and away from any combustible material or fumes.
1.
Turn off and disconnect the converter.
2.
Place the back of the converter with the mounting bracket against a
secure and flat surface.
3.
Attach the converter to the flat surface using corrosion-resistant screws.
Loading ...
Loading ...
Loading ...