Loading ...
Loading ...
Loading ...
Page 10
6. OPERATING INSTRUCTIONS
1.
Connect the converter (see Connecting Converter Cables section).
2.
Make sure the device to be operated is turned OFF.
3.
Plug the device into the converter’s AC outlet.
4.
Switch the converter’s ON/OFF switch to the ON position.
5.
Turn the device on.
6.
To disconnect, reverse the above procedure.
NOTE: If more than one device is to be powered, start one device at a time to
avoid a power surge and overloading the converter. The surge load of each
device should not exceed the converters Continuous Operation wattage rate.
USING THE CONVERTER TO OPERATE A TV OR AUDIO DEVICE:
The converter is shielded and filtered to minimize signal interference. Despite
this, some interference may occur with your television picture, especially with
weak signals. Below are some suggestions to try and improve reception.
1.
Try altering the position of the converter, antenna cables, and television
power cord. Add an extension cord from the converter to the TV so as
to isolate its power cord and antenna cables from the 12 volt power
source.
2.
Try coiling the television power cord and the input cables running from
the 12V power source to the converter.
3.
Affix one or several “Ferrite Data Line Filters” to the television power
cord. Ferrite Data Line Filters can be purchased at most electronic sup-
ply stores.
NOTE: You may hear a “buzzing” sound being emitted from inexpensive
sound systems when operated with the converter. This is due to ineffective
filters in the sound system’s power supply. Unfortunately, this problem
can only be resolved by purchasing a sound system with a higher quality
power supply or higher quality filter.
Loading ...
Loading ...
Loading ...