Loading ...
Loading ...
Loading ...
Page 13
10. IF A CONVERTER FUSE BLOWS
Your power converter is fitted with two fuses, which should not have to
be replaced under normal operating conditions. A blown fuse is usually
caused by reverse polarity or a short circuit within the device or equipment
being operated.
If a fuse does blow:
1.
Disconnect the device or equipment immediately.
2.
Find the source of the problem and repair it.
3.
Install a new fuse (25A). The fuse can be found on the back of the
converter.
IMPORTANT: Do not install a fuse with a higher amp rating than the original
fuse, as this may damage the converter and any product you use with the
converter. Make sure to correct the cause of the blown fuse before using the
converter again.
11. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
SOLUTION
Red LED is on,
audible alarm
is on, and/or
converter does
not function.
Poor contact at
terminals.
Unplug and reinsert
the 12V plug or check
connections at power
supply.
No LEDs or
output.
Fuse has blown.
See If a Converter Fuse
Blows section.
No output or
intermittent
output.
Converter shutdown.
See LED Indicator and
Shutdown Protection
section.
Loading ...
Loading ...
Loading ...