Loading ...
Loading ...
Loading ...
18
ON/OFF SWITCH
To turn the switch (1) ON, slide it forward
(Fig. 13). To turn the switch OFF, slide it back
toward the rear of the tool.
SPEED CONTROL WHEEL
The speed control wheel (1) is located at the
rear of the tool (Fig. 14). Speeds from 0 to
35,000 RPM can be set by rotating the speed
control wheel to show the desired speed (in
thousands RPM).
SELECTING THE PROPER SPEED
The different types of operations that can be
performed require that the rotary tool be used at
different speeds. The following chart outlines
some of the basic speed settings:
OPERATION
SPEED
(RPM)
Sanding
13,000
Cutting metal
35,000
Sanding wood
13,000
Cutting hard metal
29,000
Engraving metal
27,000
Sawing
25,000
De-burring
19,000
Drilling holes
17,000
Removing rust
13,000
Sharpening
9,000
Polishing
9,000
ASSEMBLY AND OPERATING
Fig. 14
1
For safety reasons, the operator must
read the sections of this Owner’s
Manual entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL
SAFETY", "SPECIFIC SAFETY RULES",
"EXTENSION CORD SAFETY" and
"SYMBOLS" before using this rotary
tool.
Verify the following every time the
rotary tool is used:
1. Safety glasses, safety goggles, or
face shield are being worn.
2. Hearing protection is being worn.
3. Accessory is in good condition
and not damaged in any way.
4. Workpiece is properly secured.
Failure to observe these safety rules
will significantly increase the risk of
injury.
!
WARNING
Fig. 13
1
Loading ...
Loading ...
Loading ...