Loading ...
Loading ...
Loading ...
16
CHANGING THE COLLET AND
ACCESSORIES IN THE FLEXIBLE SHAFT –
cont’d
ASSEMBLING & INSTALLING THE STAND
The C-clamp that holds the hang bar rod can be
mounted either horizontally or vertically
(Fig. 6a & 6b).
1. To open the clamp (1), pull back on the quick
release lever (2) and pull outward on the
clamp knob (3).
2. Clamp the C-clamp onto a work table
(horizontal surface) or other appropriate
vertical surface by pushing inward on the
clamp knob. Complete the tightening process
by turning the clamp knob clockwise (Fig. 6a
& 6b).
NOTE: Do not over tighten to avoid breaking
the clamp.
3. Thread screw (3) in the bottom of the hang
bar rod (4) into the appropriate mounting hole
(5) in the C-clamp (Fig. 7).
NOTE: Do not over tighten. Hand-tighten
only.
4. Loosen hang bar sections (6) by turning them
counter-clockwise.
5. Pull out each hang bar section approximately
5” and lock into place by turning them
clockwise.
NOTE: Do not over tighten. You will damage
the locking mechanism.
6. Insert the rotary tool hanger (7) into the top of
the hang bar rod.
7. Using the hang loop on the rotary tool (8)
hang rotary tool from the stand (Fig. 8).
ASSEMBLY AND OPERATING
Fig. 6a
Fig. 6b
Fig. 7
Fig. 5
1
Fig. 8
8
Loading ...
Loading ...
Loading ...