Loading ...
Loading ...
Loading ...
Page 9
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for dry sanding of
wood, plastic, ller and coated surfaces.
1. FIT THE SAND PAPER (SEE FIG A)
The Sand paper are placed directly onto the
base plate. The hole pattern in the base plate
and sand paper must match. Then press the
sand paper onto the base plate by hand. Firmly
press the power tool with the sand paper
against a at surface and briey switch the
power tool on. This provides for good adhesion
and prevents premature wear
Before placing on the sand paper, free the
base plate from dust/debris by lightly tapping
against it.
Fig. A
REMOVE THE SAND PAPER
Simply remove the sand paper directly.
REFERENCING USE OF HOOK AND LOOP
SANDPAPER
FIT THE SAND PAPER
Fit the sand paper over the base. Make sure
the sand paper is even with the edges and that
the dust collection holes in the base and sand
paper is aligned and that the sand paper is taut
on the base.
Lift the sand paper clamp, move away from the
clamp lever lock, and then pull down (See Fig.
B1, B2), the sand paper retaining clips will be
open. Insert one end of the sand paper under
the retaining clip. (See Fig. C)
Push the clip back into the retaining position.
Lightly stretch the paper over the base plate
ensuring that it is not folded or wrinkled then
position under the other retaining clip back into
the retaining position. Check that the paper
is at to the base plate, if not, release either
clip and reposition the paper before resetting
the clip. Switch on momentarily to check that
the sander is functioning correctly. If there is
undue vibration, repeat the paper positioning
procedure. (See Fig. D1-D3)
Fig. B1
Fig. B2
OPERATION
Loading ...
Loading ...
Loading ...