Loading ...
Loading ...
Loading ...
Figure 12
09
Under the use of electric fireplace, long press the button “HEAT (or )” for 3 seconds, the digital
display will blink, press the button “+ (or )” or “- (or )”, desired temperature can be adjusted
between 62°F ~ 82°F, each time you press the button, temperature will increase or decreased by
2°F. If temperature is greater than the environment temperature, heater will be turned on, hot air will
start blowing; If temperature shown on digital display is less than the environment temperature,
heater will not turn on, but fan will turn and blow cold air for a while and then stop.
NOTE: the default temperature setting is 62°F.
TEMPERATURE SETTING AND OPERATION
Under the use of electric fireplace, there are 2 options of shifting the downlight colors as below:
(1). Long press the button “ ” on the control panel for 3 seconds, the digital display will blink and
indicates the “01” shift, the default setting is solid white color. Each time you press the button,
downlight color can be adjusted by 1 shift and cycle through the shift of “01” ~ “13” in sequence.
(2). Press the button “DOWNLIGHT (or )” on the remote control, then press “+ (or )”, downlight
color can be adjusted by 1 shift and cycle through the shift of “01” ~ “13” in sequence; While
pressing “- (or )”, downlight color can be adjusted by 1 shift and cycle through the shift of
“13” ~ “01” in sequence.
DOWNLIGHT SETTING AND OPERATION
1. Flip switch to “O” to turn demo mode ON, which means the heater is off. This deactivates the
heating ONLY. All buttons work normally except “HEAT (or )” button.
2. Flip switch to “I” to turn demo mode OFF, which means the heater is on. All buttons work
normally.
NOTE: DEMO MODE Switch for use in retail store. One label will pre-fix onto the rocker switch in
the DEMO “I” status, when the fireplace is first used, the heater is on. Remove the label, you can flip
the switch to mode “O” or “I” to control the heater is off or on respectively.
DEMO MODE SETTING AND OPERATION
1. On the first use, the electric fireplace insert may emit a slight odor. This is normal and harmless
and will go away after the first few uses.
2. The outlet must be 120V / 60Hz / 11.67A
3. To avoid the risk of electrical shock, ALWAYS disconnect the power cord from the electrical outlet
before any internal maintenance or replacement activity or moving this electric fireplace.
4. DO NOT tighten power cord with cords of other appliances while in use.
5. DO NOT touch the vent when heater is turned on.
ATTENTION
DEMO MODE Switch for use in retail store:
Flip switch to “O” to turn demo mode ON. This deacvates
the heang ONLY. All buons work normally except “Heat”
buon.
Flip switch to “I” to turn demo mode OFF. All buons work
normally.
Demo Switch
ENABLE HEATER
ENABLE HEATER ENABLE HEAT
Loading ...
Loading ...