Loading ...
Loading ...
Loading ...
20
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
COMMONWEALTH OF MASSACHUSETTS INSTALLATION
INSTRUCTIONS
Your dryer must be installed by a licensed plumber or gas fitter. A “T” handle
manual gas valve must be installed in the gas supply line to the installed dryer at
the location of operation.
If a flexible gas connector is used to connect the dryer, the connector may not be
longer than 3 ft. (36 in./91.5 cm).
Grounding requirements
Your dryer must be grounded. If a malfunction or breakdown occurs, the
grounding reduces the risk of electrical shock by providing a path of least
resistance for the electrical current.
Gas models
For GAS MODELS ONLY: The burner may not ignite initially due to air in the gas
line. Allowing your dryer to operate on a heat setting will purge the line. If the gas
does not ignite within 5 minutes, turn your dryer off and wait 5 minutes. Be sure
the gas supply to your dryer has been turned on. To confirm gas ignition, check
the exhaust for heat.
WARNING:
Gas leaks may occur in your system, creating a dangerous situation.
• Gas leaks may not be detected by smell alone.
• Gas suppliers recommend that you purchase and install a UL-approved gas
detector.
• Install and use it in accordance with the manufacturer’s instructions.
WARNING:
• This appliance is equipped with a cord having an equipment-grounding
conductor and a grounding plug.
• The plug must be plugged into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
• Never connect the ground wire to the plastic plumbing lines, gas lines, or hot
water pipes.
Loading ...
Loading ...
Loading ...