Loading ...
Loading ...
Loading ...
6 English
off and unplug if the product will be left unattended for an extended
period of time or during electrical storms.
- If your heater suddenly stops working:
• This heater is equipped with a thermal cutout safety feature
designed to automatically shut off when overheating is detected.
See the “RESET HEATER” instructions in this guide to determine
how to check and reset the heater.
• If the heater and other electrical products suddenly stop working
at the same time, your home circuit breaker or fuse may have
tripped due to an overload of power. Consider only running your
heater on the “low” setting, only running one heater at once and
unplugging all other electrical products while running the heater,
and/or hiring an electrician to install an additional circuit to your
home’s electrical system.
SERVICING WARNING—To reduce risk of fi re, electrical shock
and injury to persons, observe the following:
- Clean your product regularly, only as is instructed in this manual.
Prior to cleaning, turn off the power on your product and unplug. Do
not use gasoline, thinners, solvents, ammonias or other chemicals
for cleaning. Refer to the CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To
avoid risk of shock, all service and/or repairs must be done by a
Vornado Authorized Service Center.
FCC CONSUMER ADVISEMENT
NOTE: This equiptment has been tested and complies with Part 15 of
the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifi cations not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Supplier’s FCC Declaration of Conformity
Unique Identifi er: Vornado Model SRTH
Responsible Party: Vornado Air LLC
Mailing Address : 415 E. 13th St., Andover, KS 67002
Contact: www.vornado.com
SAVE THESE INSTRUCTIONS
23
Español
LIMPIEZA
Dado que el calefactor mueve una gran cantidad de aire, necesitará una limpieza regular. Se recomienda limpiar el exterior del calefactor una
vez cada semanas. Si requiere mantenimiento, devuelva el calefactor a Vornado. Consulte GARANTÍA para obtener instrucciones.
1. Desconecte el calefactor antes
de limpiarlo.
2. Utilice el cepillo de su
aspiradora doméstica para
aspirar el polvo acumulado de
las entradas de aire situadas en
la parte posterior del calefactor.
3. Utilice el cepillo de su aspira-
dora doméstica para aspirar el
polvo acumulado de la rejilla de
salida frontal.
4. Limpie toda la superfi cie con un
paño suave y seco.
Debe apagar periódicamente el calenta-
dor con aire presurizado para mantener
el elemento térmico y el motor limpios
de polvo, cabello y residuos que pueden acu-
mularse dentro del calentador mientras mueve
el aire durante el uso. Esto también elimina los
olores no deseados causados por la acumu-
lación de estas partículas dentro de la unidad.
Nota: No modifi que el producto
con ningún accesorio del mercado
de accesorios.
Loading ...
Loading ...
Loading ...