Loading ...
Loading ...
Loading ...
Programming to a Genie
®
Intellicode
®
2 Garage Door Opener
Before starting, you MUST have an existing Genie
®
Intellicode
®
2 remote control programmed to the garage door opener. For help
programming a Genie Intellicode 2 remote control to your Genie operator, see your Genie owner’s manual.
The images throughout this manual are for reference only and your product may look different.
GARAGE DOOR OPENERS (continued)
1 2
3
4
On the garage door opener, press and hold the
Program/Set button until both the long and short LED’s
light up BLUE.
5
6
Press and release the Program/Set button and the long
LED will flash PURPLE.
7
8
On the Genie
®
remote control, press and release the
button that is already programmed to the garage door
opener. Both LED’s will flash PURPLE.
Bottom Button
Start with your garage door closed. Press and hold bottom button on the remote control until
the blue LED stays solid (approximately 15 seconds) then
release the button.
On the remote control, press and release the button that
you would like to program 3 times. The blue LED will blink
for up to 60 seconds.
Wait for the garage door to open, then press and release
either of the buttons on the remote to complete
programming.
LED
Test the remote control by pressing the button you
programmed in step 6. If the garage door opener does not
activate, repeat the programming steps.
IMPORTANT: The remote will activate your garage door during
programming. Ensure door is clear of ALL obstructions.
LED
9
Loading ...
Loading ...
Loading ...