Loading ...
Loading ...
Loading ...
GARAGE DOOR OPENERS
Programming to a Garage Door Opener with a Program/LEARN Button
The Program/LEARN button is typically located on the back or side panel of the garage door opener or an external receiver. For help
locating your Program/LEARN button refer to the Help section in this manual or contact your garage door opener manufacturer.
The Mini Remote Control is pre-programmed to work with a Chamberlain garage door opener with a yellow learn button. Press and
release the yellow learn button, then press and hold the button on the remote control you would like to use. If programming is not
successful, proceed through the steps below.
If you have a Genie
®
Intellicode
®
2 garage door opener go to the next page. If you have an external receiver, see External Receivers
page 12.
The images throughout this manual are for reference only and your product may look different.
Bottom Button
1
Start with your garage door closed.
2
Press and hold bottom button on the remote control until
the blue LED stays solid (approximately 15 seconds) then
release the button.
3
Press and release the Program/LEARN button on your
garage door opener. or 2 times on your door control.
4
On the remote control, press and release the button that
you would like to program twice. The blue LED will blink
and the remote control will begin sending the
preprogrammed codes to the garage door opener.
Transmission can take up to 60 seconds.
5 6
When the garage door begins to open, immediately press
and release either of the buttons on the remote control to
confirm the code and exit programming.
LED
Test the remote control by pressing the button you
programmed in step 4. If the garage door opener does not
activate, repeat the programming steps.
IMPORTANT: The remote will activate your garage door during
programming. Ensure garage door is clear of ALL obstructions.
LED
8
Loading ...
Loading ...
Loading ...