Loading ...
Loading ...
Loading ...
design provides optimum pressure. It features a 0.8 HP induction motor for quiet
operation and oil-free pump for long-lasting,reliable performance.
The procedures described in this manual are solely for this 2 gallon air compressor at a
maximum pressure of 135 PSI.
Always ensure the use of appropriately matched air tools with your Air Compressor. Be
sure that the air compressor being used can supply the appropriate volume, pressure and
delivery rate of air to the tool(s) without running continuously. Using tools or combinations
of tools that, together or separately, require more than the air compressor can deliver will
void the air compressor guarantee/warranty.
Compatible compressor and air tool - proper usage and operation
Important Information
Page 9
PRODUCT FEATURES
Electric Motor
The motor is used to power the pump. It is equipped with a thermal overload protector.
If the motor overheats for any reason, the thermal overload protector will shut it down in
order to prevent the motor from being damaged.
Air Compressor Pump
The pump compresses the air and discharges it into the tank via the piston that moves up
and down in the cylinder.
Safety Valve
This valve is used to prevent the compressor from building too much pressure. If the
pressure reaches the preset level of the motor, it will automatically pop open. You can also
pull the ring on the valve to open manually.
Pressure Switch
This switch turns the compressor on and off manually. ALWAYS set this switch to the OFF
position when the compressor is not being used and before unplugging.
Air Pressure Regulator
The regulator is used to adjust the pressure inside the line to the tool that is being used.
Turn the knob clockwise to increase the pressure and counter-clockwise to decrease the
pressure.
Tank Pressure Gauge
The gauge measures the pressure level of the air that is stored in the tank. It cannot be
adjusted by the operator and it does not indicate the pressure inside the line.
Tool Pressure Gauge
The gauge measures the regulated outlet pressure.
Air Outlet (Universal Coupler)
The outlet is connected to the 1/4” (6.4 mm) NPT air hose.
Air Tank Ball Valve
The ball valve is used to remove moisture from the air tank after the compressor is shut off.
Air Tank
The tank is where the compressed air is stored.
Power Cord
This compressor should be used on a nominal 120V grounded circuit. Use a power cord
that is equipped with a grounding plug. Verify that the compressor is plugged into an
outlet that has the same configuration as the plug. Do not use an adaptor with this
compressor.
This air compressor is ideal for a wide range of finishing applications. The 2 gallon design
Loading ...
Loading ...
Loading ...