Loading ...
Loading ...
Loading ...
High pressure air could
result in death or serious injury. Shut off unit,
unplug and release air pressure prior to
servicing.
High pressure air
containning water condensation could
result in minor or moderate injury. Do
not spray at any person.
Risk of serious eye injury
from moisture and debris. Always wear ANSI
Z87.1 safety goggles when opening ball
valve.
Operating Instructions
WARNING:
WARNING:
CAUTION:
5. Set the pressure switch to the ON position and
allow the tank pressure to build. Motor will stop
when tank pressure reaches cut-out pressure
(Fig. I).
Shut down
1. Set the pressure switch (1) to the OFF
position.
2. Unplug the power cord (2).
3. Reduce the pressure in the tank through
the outlet hose. Pulling the safety valve ring
and keeping it open will also reduce the
pressure in the tank (fig. J).
4.Set tank ball valve(4) (fig. J) to OFF to
ensure tank is drained.
1
3
4
2
FIG. J
Drain the tank
1. Set the pressure switch to the O (OFF)
position.
2. Turn air pressure regulator knob
counter-clockwise to set the outlet pressure
to zero.
3. Pull and hold ring on safety valve, allowing
air to bleed from the tank until air pressure is
minimized.
4. Place a suitable container under the unit to
catch any water.
5. Slightly tilt unit and turn ball valve
counter-clockwise to open.
6. After the water has been drained,close
the ball valve(clockwise). The air compressor
can now be stored.
4. Close the tank ball valve (1) . Plug-in
the power cord(2) (FIG.H).
2
1
OF
F
O
N
FI
G
. H
1
FIG. I
Page 12
Loading ...
Loading ...
Loading ...