Loading ...
Loading ...
Loading ...
16
EN
www.napoleon.com
N415-0518 SEP 25.20
CAUTION!
installer.
: Clean casngs periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white
spots on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the
surface to
remove any residue and paint with high temperature barbecue paint. Protect surrounding areas
from over-
spray. Follow the manufacture’s direcons for curing.
Low heat / Low ame
when valve turned to high.
For propane - improper lighng
procedure.
For natural gas - undersized supply line.
For both gases - improper preheang.
Ensure lighng procedure is followed carefully.
All gas grill valves must be in the o posion
when the tank valve is turned on. Turn tank on
slowly to allow pressure to equalize. See lighng
instrucons.
Pipe must be sized according to installaon code.
Preheat grill with both main burners on high for
10 to 15 minutes.
Excessive are-ups/
uneven heat.
Sear plates installed incorrectly.
Improper preheang.
Excessive grease and ash build on sear
plates and in drip pan.
Ensure sear plates are installed with the holes
towards the front and the slots on the boom.
See assembly instrucons.
Preheat grill with both main burners on high for
10 to 15 minutes.
Clean sear plates and drip pan regularly. Do not
line pan with aluminum foil. Refer to cleaning
instrucons.
Burners burn with yellow
ame, accompanied by
the smell of gas.
Possible spider web or other debris, or
improper air shuer adjustment.
Thoroughly clean burner by removing. See
general maintenance instrucons. Open air
shuer slightly according to combuson air
adjustment instrucons. (This must be done by a
qualied gas installer.)
Flames li away from
burner, accompanied
by the smell of gas, and
possibly dicules in
lighng.
Improper air shuer adjustment. Close air shuer slightly according to combuson
air adjustment instrucons. (This must be done
by a qualied gas installer.)
Rear and Side burners will
not light with the igniter,
but will light with a match.
Dead baery / or installed incorrectly.
Loose electrode wire or switch terminal
wires.
Liing ames on burner.
Replace with premium heavy duty baery.
Check that electrode wire is rmly pushed onto
the terminal on the back of the igniter. Check
that the lead wires from the module to the
ignion switch (if equipped) are rmly pushed
onto their respecve terminals.
Close air shuer slightly - see previous problem.
Main burner will not light
with the igniter, but will
light with a match.
Jet-re outlet is dirty or clogged. Clean jet-re outlet with a so bristle brush.
!
Loading ...
Loading ...
Loading ...