USER’S MANUAL AND OPERATING INSTRUCTIONS - Page 14

For TT15000M. Also, The document are for others Dyna Glo models: TT15CL, TT30CL, TT15CDGP, TT30CDGP, TT15CPDG, TT30CPDG, TT1-15C, TT2-30C, TT30000M

Loading ...
Loading ...
Loading ...
14
1. Stop! Read all safety information rst.
2. Open cylinder valve by turning counterclockwise .
WARNING: Stand to the side of unit while lighting. Do not stand or have any part of your body
over or in front of heater while lighting.
3. Turn heater regulator knob counterclockwise to “OFF” ( ) position.
4. Wait ve (5) minutes to clear out any gas. Then smell for gas, including near the oor. If you smell gas,
STOP! Follow the safety information on the tag attached to the heater. If you do not smell gas, go to
the next step.
5. Turn heater regulator knob clockwise to “High” ( ) position. Press in safety shut-off valve plunger.
(Fig. 5)
6. With safety shut-off valve plunger pressed in, immediately push down and release piezo ignitor button
repeatedly. This will light the burner.
7. Once the burner is lit, continue to depress the valve plunger for 30 seconds and then release. Be
careful not to shake the heater when releasing the plunger.
8. If burner goes out, repeat steps 5 through 7 or use a match. If heater will not light after repeated attempts
do not attempt to repair heater.
9. When burner is lit, turn heater regulator knob to desired heat setting “LOW” ( ), “MED” ( ), or “HIGH” ( ).
10. On dual burner models light both burners when maximum heat is needed.
Use one burner to conserve fuel.
LIGHTING INSTRUCTIONS FOR PIEZO IGNITION MODELS (CONTINUED)
TURNING OFF THE HEATER
1. Tightly close propane tank valve by fully turning clockwise .
2. Turn the heater regulator knob to the “OFF” ( ) position. Wait at least 30 minutes for the heater to cool
before handling heater.
3. Always remove the heater from the propane tank after each use and store indoors. Do not store heater while
attached to propane tank. Do not store propane cylinders in a building, garage or any other enclosed area.
VENTILATION
Always be sure to supply proper ventilation while operating this heater.
Provide a minimum of 1/2 square foot opening for fresh air supply for 15,000 BTU’s
of heat and one square foot opening for 30,000 BTU’s of heat.
PROPANE TANK TOP HEATER
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Loading ...
Loading ...
Loading ...