Loading ...
Loading ...
Loading ...
12
5. Once the burner is lit, continue to depress the valve
plunger for 30 seconds and then release. Be careful
not to shake the heater when releasing the plunger.
6. If the burner does not light within 10 seconds, turn
regulator knob to the “OFF” ( ) position. Wait at least
ve (5) minutes for the gas to dissipate before relighting.
7. If heater will not light after repeated tries, do not
attempt to repair heater. Return heater to nearest
authorized service center or to the address on back
of this manual, freight prepaid.
8. After burner lights, turn the heater regulator knob to the desired heat setting “LOW” ( ), “MED” ( ), or
“HIGH” ( ).
9. For dual burner models only : Light both burners when maximum heat is needed. Use one burner
to conserve fuel. Repeat steps to light second burner.
FIGURE 4
LIGHTING INSTRUCTIONS WHEN USING MATCH (CONTINUED)
1. Open Cylinder valve by turning
counterclockwise .
2. Turn heater regulator knob
clockwise to the
“High” ( ) position. (Fig. 4)
WARNING: Stand to the side of unit while
lighting. Do not stand or have any part of your
body over or in front of heater while lighting.
CAUTION: Do not insert match
into air inlet holes in mixing tube.
4. Push in the safety shut-off valve plunger (Fig. 5)
WARNING: Do not push in safety shut-off
valve plunger before inserting lit match.
3. Do not attempt to light one burner off of
the other. Use one match per burner.
Locate ignition hole in side of burner.
(Fig. 5) Insert a lit match through ignition hole.
FIGURE 5
PROPANE TANK TOP HEATER
TT15 Series
Safety
Shut-off Valve
Wing Bolt
Electrode
Heat Regulator Knob
Piezo
Ignition Hole
Support Leg
Burner Front
Place lit match through ignition hole.
TT30 Series
Ignition Hole
Tip Over Switch
Safety
Shut-off Valve
Air Inlet Hole
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Loading ...
Loading ...
Loading ...