Loading ...
Loading ...
Loading ...
Page 14
LINE REPLACEMENT
NOTICE: Always use triangle-shaped
twisted nylon cutting line with a diameter
that does not exceed 0.08 in. (2.0 mm).
Using line other than that specied may
cause the string trimmer to overheat or
become damaged.
WARNING:
Never use metal-
reinforced line, wire, or rope, etc. These
can break off and become dangerous
projectiles.
WIND THE SPOOL WITH NEW
LINE
WARNING:
To prevent serious
personal injury, remove the battery pack
from the tool before servicing, cleaning,
changing attachments or removing
material from the unit.
1. Press the two release tabs on the spool
base and remove the spool retainer by
pulling it straight out (Fig.11).
2. Remove the spool. Use a clean cloth
to clean the inner surface of the spool
retainer and spool base.
NOTICE: Always clean the spool retainer
and spool base before reassembling the
trimmer head.
3. Check the spool retainer, spool and
spool base for wear parts.
4. Take approximately 15 ft. (4.5 m) of 0.08
in. (2.0 mm) diameter cutting line. Fold
the line in half and then adjust it so that
one end is 4.5 in. (11 cm) longer than the
other (Fig.12).
5. Hook the folded end of the cutting line
onto either of the slots in the spool.
OPERATION
6. Wind the line, in two even and tight
layers, onto the spool. Wind the line in
the direction indicated on the spool.
NOTICE: Failure to wind the line in the
direction indicated will cause the trimmer
head to operate incorrectly.
7. Place the ends of the line in the two
opposite notches in the spool, with
approximately 5 in. (12.5 cm) protruding
from each side (Fig.13).
8. Align the notches of the spool from
which the lines protrude with the eyelets
in the spool retainer and position the
spool in the retainer (Fig.14).
9. Holding the spool and spool retainer,
grasp one end of the line and pull it to
release the line from the notch in the
eyelet (Fig.15). Repeat with the other
end.
10. With the spool base facing downward,
align the slots in the spool retainer with
the tabs on the spool base and press
the retainer evenly down until it snaps
into place (Fig.16).
NOTICE: Make sure that the tabs on the
spool base snap into place or the spool
will come out during operation.
CAUTION:
After each line
replacement, tap the bump knob on the
ground for several times before trimming
on grass to check that whether the cutting
line can be released normally.
Loading ...
Loading ...
Loading ...