Loading ...
Loading ...
Loading ...
7
Alternatively, the water tank may be filled
without removing it from the base unit (17).
Simply open the filling cap (12), and fill the
water tank with water to the max fill line.
1a) Removing and filling the water tank 1b) Filling the water tank in situ
Remove the detachable water tank (13) using the
water tank removal tabs (19), open the filling cap
(12), and fill with water to the max fill line. Replace
the water tank.
IN HARD WATER AREAS, WE RECOMMEND A
MIX OF 50% TAP WATER AND 50% DISTILLED,
DEIONISED OR DEMINERALISED WATER.
Never use battery topping up fluid or water
containing any substances like starch, sugar,
fragrant additives or defrosted water from a
refrigerator.
NOTE: Please see point 2 of ‘Exclusions’ on page 12.
Re-filling during use
If the water level is too low, the low water indicator
will illuminate and the unit will not produce steam.
If this happens, refill the detachable water tank
(13) with water.
If a different temperature than IntelliTemp
setting is required to suit the garment (see
‘Temperature guide’ on page 6), you may adjust
the temperature as follows: press the select
button (20) repeatedly until the required
temperature setting indicator (22/23/24/25) is
displayed. Pressing the select button cycles the
options as shown in the next step.
2) Default IntelliTemp Setting 3) Temperature Selection
Plug the appliance into a mains outlet to switch
the product on. A beep will be heard and the
IntelliTemp logo (31) will illuminate on the control
panel (8). The default temperature is the
IntelliTemp setting, this allows the appliance to
iron all ironable fabrics without the temperature
needing to be adjusted. However, do not iron
any fabric with this symbol . The Intellitemp
setting indicator (31) will stop flashing and
remain constant when the IntelliTemp setting is
reached.
Using the Steam Generator
RN333300 MUK Rev3.qxp_IB 05/06/2018 09:37 Page 7
Loading ...
Loading ...
Loading ...