Loading ...
Loading ...
Loading ...
26 Español
toma de corriente con un calce no firme puede provocar que el
enchufe se sobrecaliente y cause un incendio. Asegúrese de que el
enchufe calce firmemente en la toma de corriente. Durante el uso,
verifique frecuentemente que el enchufe o la toma de corriente
no estén calientes. Si es así, deje de utilizar el calefactor y haga
reemplazar la toma de corriente por un electricista cualificado.
- Nota: Los calefactores utilizan más corriente que los artefactos
pequeños, por lo que el sobrecalentamiento de la toma de corriente
puede ocurrir aunque no se haya producido con otros artefactos.
- Nunca ignore las señales de un problema eléctrico, tales como:
cubiertas de tomas de corriente calientes, chispas al enchufar o al
utilizar, luz parpadeante/atenuándose durante el funcionamiento.
Apague y desenchufe inmediatamente el artefacto si nota
dichos problemas. Comuníquese con un electricista cualificado
para investigar las causas posibles antes de hacer funcionar el
artefacto nuevamente.
- Antes de mover, colocar en otra parte, reparar, limpiar o cuando
no esté en uso, utilice los controles para apagar la alimentación y
desenchufe. Para desconectar de la toma de corriente, tire solo del
enchufe. También, apague y desenchufe el producto si lo dejará sin
supervisión durante un largo período de tiempo o durante tormentas
eléctricas.
- Si el calefactor deja de funcionar repentinamente:
• Este calefactor está equipado con un sistema de apagado térmico
seguro, diseñado para apagar el calefactor cuando se detecta
una situación de sobrecalentamiento. Consulte las instrucciones
“REINICIAR CALEFACTOR” que aparecen en esta guía para
15
English
Your heater has a multilevel safety shut-off system designed to prevent
overheating. Overheating may occur when the inlets or outlet are blocked. If
this happens, the safety shut-off system cuts power to the heater and you must
manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Press Power button On. Your Sharper Image Heater should now
function normally.
If the heater and other electrical products suddenly stop working at the same
time, your home circuit breaker or fuse may have tripped due to an overload of
power. Consider only running your heater on the “low” setting, only running one
heater at once and unplugging all other electrical products while running the
heater, and/or hiring an electrician to install an additional circuit to your home’s
electrical system.
NOTE:
If the safety shut-off system repeatedly shuts off your heater or if it will
not reset after following the above procedure, call Sharper Image Consumer
Services Department toll-free at 833-800-8669.
RESET HEATER
Loading ...
Loading ...
Loading ...