User Manual Frigidaire GLMV168CB Over-the-Range Microwave

All of our over-the-range (OTR) microwaves are factory preset to vent internally – it will recirculate the air back into the room. However, it can also be converted to vent externally, or outside, if you prefer.

If this is your preference, please let the installer know before they begin the initial installation and they will share the option that best suits your installation situation.

Your over-the-range (OTR) microwave, it will come with all the necessary installation hardware. Each of our models comes with a complete set of installation hardware.

It only takes five easy steps to change this light bulb.

Pull on your safety gloves, and let's get it done. First, unplug the microwave or turn off the power at the main circuit breaker.
Then, remove the the bulb covering mounting screws at both positions under the microwave.
Remove and replace the old bulbs with 30-watt appliance bulbs.
Reinstall the bulb cover and mounting screws.
That's it! Plug the mircowave back into the power supply or turn the power back on at the main circuit breaker.

Just follow these simple instructions, and you'll have your oven light changed in no time.

First, unplug the microwave, or turn off the power at the main circuit breaker.
Remove the mounting screws, and pull the vent grill away from the unit.
Remove the charcoal filter, if used, by pushing it inwards. Then turn, and pull it away from the unit. Now you can open the light cover by pulling up on the front edge.
Unscrew the old light bulb and replace it with an equivalent, new 30-watt bulb.
Now, carefully push the light cover back into place, then the charcoal filter, and the vent grill. Be sure to engage the bottom and top tabs. Finally, replace the vent grill mounting screws and you're done.
Remember to plug the microwave back into the power supply, or turn the power back on, at the main circuit breaker.