User Manual - Page 12

For KSD25HRG. Also, The document are for others Kelvinator models: KSV25CRG, KSV35CRG, KSV70CRG, KSV25HRG, KSV35HRG, KSD35HRG, KSV50HRG, KSD50HRG, KSV70HRG, KSD70HRG, KSV80HRG, KSD80HRG

Loading ...
Loading ...
Loading ...
12 Timer operation
Timer operation
ON/OFF
MODE
FAN
TEMP
SLEEP SWING DIRECT
LED FOLLOW METURBO SELF CLEAN
TIMER
OFF
TIMER
ON
SILENCE
FP
Press the TIMER ON button can set the auto-on time of the unit.
Press the TIMER OFF button can set the auto-off time of the unit.
To set the Auto-ON time
1. Press the TIMER ON button. The remote controller shows
TIMER ON, the last Auto-on setting time and the signal "H"
will be shown on the LCD display area. Now it is ready to reset
the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired Auto-on time.
Each time you press the button, the time increases by half an
hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER ON ,there will be a one second delay
before the remote controller transmits the signal to the air
conditioner. Then, after approximately another 2 seconds,
the signal "H" will disappear and the set temperature will
re-appear on the LCD display window.
To set the Auto-OFF time
1. Press the TIMER OFF button. The remote controller shows
TIMER OFF, the last Auto-off setting time and the signal "H"
will be shown on the LCD display area. Now it is ready to reset
the Auto-off time to stop the operation.
2. Push the TIMER OFF button again to set desired Auto-off time.
Each time you press the button, the time increases by half an
hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER OFF, there will be a one second delay
before the remote controller transmits the signal to the air
conditioner. Then, after approximately another 2 seconds, the
signal "H " will disappear and the set temperature will
reappear on the LCD display window.
WARNING
caution
When you select the timer operation, the remote controller
automatically transmits the timer signal to the indoor unit for
the specified time. Therefore, keep the remote controller in
a location where it can transmit the signal to the indoor unit
properly.
Timer setting is in half hourly intervals up to 10 hours then
hourly intervals to 24 hours
1
2
Loading ...
Loading ...
Loading ...