Loading ...
Loading ...
Loading ...
4
CONTROL PANEL AND FEATURES
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
Knob does not advance during the progress of the cycle –
see cycle status lights for each stage of the process.
See “Cycle Guide” for detailed descriptions of cycles.
Select the cycle most suitable for your load. Delicates will add
a low amount of water for smaller loads and Power Wash
®
/
Heavy Duty will add the most amount of water for large or bulky
loads. Items need to move freely. Tightly packing can lead to
poor cleaning performance and may increase wrinkling and
tangling.
The washer is factory set for multiple progressive spray rinses.
Removing the J-4 Jumper on the Coinslide Interface Control
inside the console will change the rinse setting to a bath-type
rinse, which should be used when installing the optional Fabric
Softener Dispenser.
WASH TEMP
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and soils
being washed. For best results and following the garment label
instructions, use the warmest wash water safe for your fabric.
•
Warm and hot water may be cooler than your previous
washer.
•
Even in a cold and cool water wash, some warm water may
be added to the washer to maintain a minimum temperature.
NOTE: To get hotter temperatures, pull the J-3 Jumper.
1
2
3
START BUTTON
Press to start the selected cycle. Press and hold
for 3 seconds to pause the cycle and unlock the lid.
Press and hold for 10 seconds to cancel a cycle.
NOTE: If the wash basket is spinning, it may take several
minutes to unlock the lid.
CYCLE STATUS LIGHTS INDICATOR
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
SENSING LOAD
When the Start button is pressed, the washer will fill to
the selected cycle water level. If the lid is closed when the
washer is done filling, the lid will lock and the washer will
begin operation.
If the lid is open when the water stops entering the washer,
the cycle will not begin until the lid has been closed. If the
cycle has not been started within 10 minutes of the water
filling the washer, your cycle will cancel and the washer will
pump out the water.
SOAK/WASH
You will hear the agi-peller moving the load. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected cycle
and sensed load size.
RINSE
You will hear sounds similar to the wash cycle as the washer
rinses and moves the load. You may hear the motor turning
on briefly (short hum) to move the basket while filling. Fabric
softener will be added in the rinse cycle if an optional
dispenser is installed – unless the J-4 Jumper is removed,
which will change spray rinses to “bath-type” rinse. The
J-4 Jumper should be removed when installing the optional
Fabric Softener Dispenser.
Some cycles use progressive spray rinsing. After draining
and spinning out wash water, the washer will continue
to spin and spray in rinse water.
4
Not all features and options are available on all models.
Appearance may vary.
Enables Progressive Rinses
(jumper loaded)
All Bath Rinses & Added
Wash Water (jumper
removed)
Coin Slide Interface Module
4 3
2
1
Enables Temperature Control
(jumper loaded)
Disables Temperature Control
(jumper removed)
Loading ...
Loading ...
Loading ...