Loading ...
Loading ...
Loading ...
Wait a few minutes after turning the
engine off before you check the oil.
Put your fingers under the front
edge of the hood near the center.
Slide your hand to the left until
you feel the hood latch handle.
Push this handle up to release it.
Lift up the hood.
If the hood latch handle moves
stiffly, or if you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated.
Pull the support rod out of its clip
by holding the grip, and insert the
end into the designated hole in the
hood.
To close the hood, lift it up slightly
to remove the support rod from
the hole. Put the support rod back
into its holding clip. Lower the
hood to about a foot (30 cm) above
the fender, then let it drop. Make
sure it is securely latched.
Remove the dipstick (orange
handle).
Insert it all the way back in its tube.
Wipe off the dipstick with a clean
cloth or paper towel.
3.
1.
2.
3.2.
CONTINUED
Service Station Procedures
Oil Check
Before Driving
183
DIPSTICK
CLIP
LATCH
DX, Canadian DX-G, LX, EX
GRIP
SUPPORT ROD
Main Menu
Table of Contents
Main MenuMain MenuMain MenuMain Menu
Loading ...
Loading ...
Loading ...