Loading ...
Loading ...
Loading ...
20_ setting up
flat-blade screwdriver (-)
Control Lever
Both control levers must be touching the
floor to avoid possible personal injury or
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
MAKING MINOR
ADJUSTMENTS TO THE DOOR
OR IN DOOR
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Adjustment
part
Fixed part
The left door is fixed. To make minor door
adjustments, adjust only the right door.
Snap ring
The height of a door or in door can be adjusted
using the provided snap rings, which come in 4
different sizes (1 mm, 1.5 mm, 2 mm, and 2.5mm).
CAUTION
To adjust the height of a door
Check the height difference between the doors,
and then raise and hold the lower door.
• Insert the snap ring in the gap between the in
door and the HINGE-SHAFT.
(applicable models only)
• Insert only one snap ring for this
purpose. Two or more snap rings may
slip out or make a rubbing noise.
• Keep the snap rings out of children’s reach, and
keep them for future use.
• Do not raise the door too much. The door can
contact and damage the top cover.
MAKING MINOR
ADJUSTMENTS BETWEEN
OUT DOOR AND IN DOOR
(APPLICABLE MODELS ONLY)
After raising the out door, insert the supplied snap
ring in the gap between the OUT DOOR and the
HINGE-SHAFT.
CAUTION
DA68-02916G-13.indb20 2018.3.24.10:19
Loading ...
Loading ...
Loading ...