Loading ...
Loading ...
Loading ...
21
English
EN
Speakers
Center speaker:
• Output power: 50 W RMS (30% THD)
• System: 1 x 63.5 mm (2.5") full range
• Speaker impedance: 4 ohm
• Speaker drivers: 1 x 63.5 mm (2.5") woofer
• Dimensions (WxHxD): 6.30 x 3.30 x 3.20
(inches)
• Weight: 0.35 kg
• Cable length: 6.50 ft
Front/Rear speaker:
• Output power: 4 x 50 W RMS (30% THD)
• Speaker impedance: 4 ohm
• Speaker drivers: 1 x 63.5 mm (2.5") full range
• Dimensions (WxHxD): 3.30 x 6.30 x 3.20
(inches)
• Weight (front): 0.35 kg/each
• Weight (rear): 0.35 kg/each
• Cable length (front): 9.80 ft
• Cable length (rear): 23 ft
Remote control batteries
• 2 x AAA-R03-1.5 V
Laser
• Type: Semiconductor laser GaAIAs (CD)
• Wave length: 645 - 665 nm (DVD), 770 - 800
nm (CD)
• Output power: 6 mW (DVD), 7 mW (VCD/
CD)
• Beam divergence: 60 degrees.
9 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, visit www.philips.com/support.
If you contact Customer Care Center, you will be
asked for the model and serial number of your
product. The model number and serial number are
on the back or bottom of your product. Write the
numbers here:
Model No. ________________________
Serial No. ________________________
Main unit
The buttons on the home theater do not work.
• Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
Picture
No picture.
• Make sure that the TV is switched to the
correct source for the home theater.
No picture on a TV connected through HDMI.
• Make sure that the HDMI cable is not faulty. If
it is faulty, replace it with a new cable.
• If this happens when you change the HDMI
video resolution: 1) ) Press
to open the
disc compartment. 2) Press Navigation
buttons (left). 3) Press ZOOM.
• Wait for 10 seconds for auto recovery, or
change the HDMI video setting (see 'Picture
resolution' on page 16).
Discdoesnotplayhigh-denitionvideo.
• Make sure that the disc contains high-
denition video.
• Make sure that the TV supports high-
denition video.
• Use an HDMI cable to connect to the TV.
Loading ...
Loading ...
Loading ...